I ended up getting "not found’’

[Lembris]

I tried this and the server could recognise them I ended up getting "not found’’
Can someone assist please

[Kal_Lam]

Welcome to the community, @Lembris! Could you also share a screenshot of your app’s settings with the community from SETTINGS>Server?

[Lembris]

@Kal_Lam thanks. In my case, i had two accounts with the same server One account is used for users and one account is set as administrator ( can edit, resubmit, etc.). Some forms can be seen by user but some it does not accept.

[Lembris]

When I share the project it says users not available

[Kal_Lam]

@Lembris, would you mind sharing with me the following information through a private message so that I could have a closer look at your case:

• Username (for both the admin and the enumerators account)
• Server

Note: You could share with me a private message as outlined in the post discussed previously:

How do i send a private message to a user in the community forum?

Hi @Lavinia, You could send a private message to a user in the community forum as follows: Option 1: Sending a private message Step 1: Select the Reply button as boxed in red below. [Image 1] Step 2: Select the Reply button once again, but now from this place, as shown in the image below. [Image 2] Step 3: Now select New Message as shown in the image below. [Image 3] Option 2: Sending a private message to me Step 1: Click on my username Kal_Lam. Step 2: Then on the right, click the…